Powered By
KeylessCanada.com

PROGRAMMING INSTRUCTIONS:

How to Program a 2010 Mercury Mountaineer Keyless Entry Remote Key Fob

0
12

Compare
SKU: Remote Mercury Mountaineer 2010 Categories: , , , Tags: , , ,

Description

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Mercury Mountaineer

Step-by-Step Programming Instructions:

1. Turn the ignition from OFF to RUN eight times within ten seconds, with the eighth time ending in RUN. The door locks will cycle to confirm programming mode.
2. Within 20 seconds, press any button on the first keyless remote. The door locks will cycle to confirm programming.
3. Within 20 seconds, press any button on the second keyless remote. The door locks will cycle again to confirm programming.
4. Turn the ignition to OFF. Locks will cycle again to indicate the end of programming mode.

Use this Procedure if you have a Remote Head Key:
You must have two previously programmed keys and then the new unprogrammed key readily accessible. If you do not have two previously programmed keys, you will need a Locksmith to cut and program a second key. If you have one working key, you can Buy a Programmer and Key Here.

1. Insert the first previously programmed key into the ignition.
2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
3. Switch the ignition off and remove the first programmed key from the ignition.
4. After three seconds but within ten seconds of switching the ignition off, insert the second previously programmed key into the ignition.
5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
6. Switch the ignition off and remove the second previously programmed key from the ignition.
7. After three seconds but within ten seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
9. Remove the newly programmed key from the ignition. If the key has been successfully programmed, it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait 10 seconds and repeat Steps 1 through 8.

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Mercury Mountaineer

Leave a reply

X
X