Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1999 Pontiac Grand Am

Step-by-Step Programming Instructions:

If your 1999 Grand Am was built late in 1999, there is no on-board programming procedure available for this vehicle. Special equipment needs to be connected to the vehicle to program the keyless remote. However, if your 1999 Grand Am was built early in 1999, you can follow the programming instructions below:

1. Ensure the ignition is in the OFF position.
2. Locate the programming connector in the trunk (driver’s side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may need to pull back trim to access the connector.
3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Ensure the terminals remain connected throughout the programming procedure.
4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response, the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been accepted, and all existing remotes have been erased.
5. Repeat the previous step for each additional remote (including any existing remotes). Do not remove the jumper wire between programming of remotes.
6. Remove the jumper wire from the Keyless Remote Connector.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1999 Pontiac Grand Am