How to Program a 2015 Cadillac SRX Ignition Smart Chip Key Transponder
Step by Step How to Programming Instructions:
If you have one programmed remote and want to add another:
1. Ensure the vehicle is off.
2. Place the working remote(s) in the cup holder and have the new remote with you.
3. Insert the key into the key lock cylinder on the outside of the driver’s door.
4. Turn the key to the unlock position five times within ten seconds.
5. The Driver Information Center (DIC) will display “Ready to Learn Electronic key #2, 3, 4, etc.”
6. Insert the new remote into the transmitter pocket with the buttons facing the front of the vehicle (located inside the center console between the driver and front passenger seats).
7. Press the ignition. Once the remote is learned, the DIC will indicate it is ready to program the next remote.
8. Remove the remote from the transmitter pocket and press unlock.
9. To program additional remotes, repeat steps 6 through 8.
10. When all additional transmitters are programmed, press and hold the ignition for ten seconds to exit programming mode.
If you have no working remotes:
1. Ensure the vehicle is off.
2. Insert the key into the key lock cylinder on the outside of the driver’s door.
3. Turn the key to the unlock position five times within ten seconds.
4. The DIC will display “REMOTE LEARN PENDING, PLEASE WAIT.”
5. Wait ten minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN” and then press the ignition. The DIC will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
6. Repeat step 5 two additional times. After the third time, all previously known remotes will no longer work with the vehicle. Remaining remotes can be relearned during the next steps.
7. Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle.
8. Press the ignition. Once the remote is learned, the DIC will indicate it is ready to program the next remote.
9. Remove the remote from the transmitter pocket and press unlock.
10. To program additional remotes, repeat steps 7 through 9.
11. When all additional transmitters are programmed, press and hold the ignition for ten seconds to exit programming mode.
