Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Ford F350 Super Duty

Step-by-Step Programming Instructions:

You need two programmed working keys to add a third. Your new key must be cut before starting the procedure. Note: Correct speed in turning the key off and on is crucial to entering program mode; it may require several attempts.

1. Insert the first programmed working key and cycle the key from OFF to Run (not Start) eight times, almost as fast as you can. (Note: Going too fast can also cause issues.)
2. Quickly insert the second programmed working key and cycle it from OFF to RUN (not Start) two times, almost as fast as you can. The dash will display the SecuriCode keypad door code.
3. Quickly insert the new unprogrammed key and cycle it from OFF to RUN (not Start). The dash should display “Key Programmed.” The hazard lights may flash, and door locks may cycle. Turn the key off and remove it.
4. Test the new key.

For Ford F350, F350, F450, F550 with the smart key system, ensure you have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access keys readily accessible. Make sure your vehicle is off before starting this procedure. Close all doors before beginning, and keep them closed throughout the process. Complete all steps within 30 seconds of starting the sequence. If you perform any steps out of sequence, stop and wait for at least one minute before starting again. Read and understand the entire procedure before beginning.

1. Remove the key blade from the transmitter.
2. Remove the tray and cover from the center console. With the buttons facing upward, place the first intelligent access key in the backup slot.
3. Press the push button ignition switch.
4. Wait five seconds, then press the push button ignition switch again.
5. Remove the intelligent access key.
6. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.
7. Wait five seconds, then press the push button ignition switch again.
8. Remove the intelligent access key.
9. Wait five seconds, then place the unprogrammed intelligent access key in the backup slot and press the push button ignition switch. Programming is complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key. If programming was unsuccessful, wait 10 seconds and repeat steps 1 through 7.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Ford F350 Super Duty