404 Not Found


nginx
404 Not Found

404 Not Found


nginx
How to Program a 2016 Ford Edge Ignition Smart Chip Key Transponder - KeyLessCanada : Instructions

Powered By
KeylessCanada.com

PROGRAMMING INSTRUCTIONS:

How to Program a 2016 Ford Edge Ignition Smart Chip Key Transponder

0
26

Compare
SKU: Ford Edge 2016 Categories: , , , Tags: , ,

Description

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2016 Ford Edge

Step-by-Step Programming Instructions:

You must ensure that two previously programmed smart keys are present in the vehicle, along with the new unprogrammed smart key. It’s important to note that your vehicle can only accommodate a maximum of four smart keys. If you intend to replace a previously programmed smart key with a new one, or if you already have four smart keys programmed, you’ll need to contact a Locksmith to have them erased and reprogrammed.

Before commencing this procedure, make sure the vehicle is switched off and all doors are closed and remain closed throughout. Follow the steps precisely as outlined below, ensuring that each action is completed within 30 seconds of starting the sequence. If any steps are performed out of order, pause and wait for at least one minute before resuming. Familiarize yourself with the entire procedure before beginning.

1. Open the floor console storage compartment lid and insert the intelligent access key into the backup slot, with the buttons facing the rear of the vehicle and the key ring up.
2. Repeat this step with the smart key, ensuring it is inserted with the buttons facing the rear of the vehicle and the key ring up.
3. Press the push button ignition switch.
4. After a five-second pause, press the push button ignition switch again.
5. Remove the smart key from the backup slot.
6. Within 10 seconds, insert the second programmed smart key into the backup slot and press the push button ignition switch.
7. After a five-second pause, press the push button ignition switch again.
8. Remove the smart key from the backup slot.
9. Wait for five seconds, then insert the unprogrammed smart key into the backup slot and press the push button ignition switch.

Upon completing these steps, the programming process is finished. Verify that the remote control functions operate and that your vehicle starts with the new smart key. If programming was unsuccessful, wait 10 seconds and repeat Steps 1 through 7. **If you possess only one working Smart Key, consider purchasing a Programmer.

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2016 Ford Edge

Leave a reply

X
X