Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2011 Nissan Versa

Step-by-Step Programming Instructions:

IMPORTANT: Before entering programming mode, ensure you have all the transmitters you will be using on the vehicle. Once you program a transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program them again.

1. Close and lock all doors using the driver’s side power lock/unlock switch.
2. Insert the key into the ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw the key completely from the ignition cylinder each time. If this procedure is performed too fast, the system will not enter programming mode.
3. Insert the key into the ignition cylinder and turn it to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch, and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).
6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch, and open the driver’s side door. Even if your original key and remote were separate, you can upgrade to a key with built-in remote buttons.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2011 Nissan Versa