Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Toyota Sienna

Step-by-Step Programming Instructions:

1. Begin with the key out of the ignition, the driver’s door open, all other doors closed, and the driver’s door unlocked.
2. Perform these steps within 5 seconds:
A. Insert the key into the ignition (Do NOT turn), then pull the key out.
B. Repeat step A.
3. Perform these steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door again.
C. Insert the key into the ignition (Do NOT turn), then pull the key out.
4. Perform these steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door again.
C. Insert the key into the ignition and leave it in the ignition.
D. Close the driver’s door.
E. Turn the ignition to ON (Do NOT start), then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once, indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Open the driver’s door.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Toyota Sienna