Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Ford Expedition

Step-by-Step Programming Instructions:

**For Separate Key and Remote:**

1. Turn the ignition from OFF to RUN eight times within ten seconds, with the eighth time ending in RUN. The door locks will cycle to confirm programming mode.
2. Within twenty seconds, press any button on the first keyless remote. The door locks will cycle to confirm programming.
3. Within twenty seconds, press any button on the second keyless remote. The door locks will cycle again to confirm programming.
4. Turn the ignition to OFF. Locks will cycle again to indicate the end of programming mode.

**For Remote Head Key Combo System (Requires two previously programmed keys):**

1. Insert the first previously programmed key into the ignition.
2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
3. Switch the ignition off and remove the first programmed key from the ignition.
4. After three seconds but within ten seconds of switching the ignition off, insert the second previously programmed key into the ignition.
5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
6. Switch the ignition off and remove the second previously programmed key from the ignition.
7. After three seconds but within ten seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
9. Remove the newly programmed key from the ignition. If the key has been successfully programmed, it will start the engine and operate the remote entry system (if the new key is an integrated key head transmitter). If it was not programmed successfully, wait ten seconds and repeat Steps 1 through 8.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2010 Ford Expedition