Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Toyota RAV4

Step-by-Step Programming Instructions:

These instructions are specifically for programming the remote portion of your Key/Remote combo. You’ll still need to have the key blade cut, and if your key has a transponder chip, you’ll need to have that programmed by a locksmith.

1. Begin with the key out of the ignition, the driver’s door open, and all other doors closed and unlocked.
2. Perform the following steps within 5 seconds:
A. Insert the key into the ignition (Do NOT turn) and then pull it out.
B. Insert the key into the ignition (Do NOT turn) and then pull it out.
3. Perform the following steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door.
C. Insert the key into the ignition (Do NOT turn) and then pull it out.
4. Perform the following steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door.
C. Close the driver’s door.
D. Insert the key into the ignition and leave it in the ignition.
E. Turn the ignition to ON (Do NOT start) and then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should automatically lock and unlock, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform the following steps within 40 seconds:
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once, indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6, as the remote was not accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Open the driver’s door.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Toyota RAV4