How to Program a 2008 Subaru Tribeca Keyless Entry Remote Key Fob

Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Subaru Tribeca

Step-by-Step Programming Instructions:

1. Sit in the driver’s seat, ensuring all doors and the rear gate or trunk lid are closed.
2. Open and close the driver’s door once within 45 seconds.
3. Repeat step 2: open and close the driver’s door once more.
4. Turn the ignition key from LOCK to ON ten times within 15 seconds. An electronic tone will sound once, followed by a continuous buzzer and flashing interior light until the transmitter codes are fully registered. If this step isn’t completed within 45 seconds, start over.
5. Within 45 seconds, open and close the driver’s door once more. An electronic tone will sound for 30 seconds. Failure to perform this within 15 seconds will result in an error; in this case, repeat from step 3.
6. While the electronic tone is sounding, press the power door lock button to LOCK the same number of times as the leftmost digit of the transmitter code. Repeat this for the remaining seven digits of the code, pressing the UNLOCK side within five seconds after each series. After entering the eighth digit for the second time, another electronic tone will sound for 30 seconds.
7. If the interval between pressing the knob exceeds five seconds, an error will occur; repeat from step 4. If an error occurs six times, repeat from step 3.
8. If the code entered the second time does not match the first, repeat from step 5. If an error occurs five times, repeat from step 3.
9. To program another transmitter code (up to four total), repeat from step 4. Once all necessary codes are programmed, remove the key from the ignition switch and test the remotes.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Subaru Tribeca