Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2007 Toyota Tundra

Step-by-Step Programming Instructions:

1. Begin with the key out of the ignition, the driver’s door open, all other doors closed, and the driver’s door unlocked.
2. Perform these steps within 5 seconds:
A. Insert the key into the ignition (Do NOT turn) and then pull the key out.
B. Repeat step A.
3. Perform these steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door again.
C. Insert the key into the ignition (Do NOT turn) and then pull the key out.
4. Perform these steps within 40 seconds:
A. Close then open the driver’s door.
B. Close then open the driver’s door again.
C. Insert the key into the ignition and leave it in the ignition.
D. Close the driver’s door.
E. Turn the ignition to ON (Do NOT start) then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once, indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Open the driver’s door.

For Double Cab:

1. Start with the key out of the ignition, the driver’s door open, all other doors closed, and the driver’s door unlocked.
2. Insert the key into the ignition (Do NOT turn) and then pull the key out.
3. Perform these steps within 40 seconds:
A. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles starting with lock. Use an even pace, trying to go about one cycle per second (1 cycle = 1 lock and 1 unlock).
B. Close, then open the driver’s door.
4. Perform these steps within 40 seconds:
A. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles starting with lock. Use an even pace, trying to go about one cycle per second (1 cycle = 1 lock and 1 unlock).
B. Insert the key into the ignition cylinder.
C. Turn the ignition to ON (Do NOT start) then back to OFF.
D. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle automatically, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds:
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once, indicating successful programming. If the door locks do not cycle, or cycle twice, repeat steps A and B in step 6 as your remote has not been accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Close the driver’s door.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2007 Toyota Tundra