Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2005 Subaru Legacy

Step-by-Step Programming Instructions:

NOTE: These instructions may appear complicated at first glance, but they’re actually straightforward if you carefully read and understand them before beginning. Don’t worry if you don’t get it right the first time; you can repeat the process as many times as needed.

1. Depending on your key or remote style, you’ll either need to pop off the back cover with a bladed screwdriver (for Separate Remote) or unscrew the back cover with a small Phillips screwdriver (for Remote Head Key).

2. Find the ID number inside the remote and write it down. It will be an 8-digit number. If there are two rows, use the one with numbers only, no letters. Note:
– Separate Remote: This procedure will program your remote entirely.
– Remote Head Key: This will only program the remote; you’ll need to have the key cut and transponder programmed to your car by a locksmith.

3. Ensure all doors, including the trunk, are shut.

4. Sit in the driver’s seat and close the door (all doors shut), then proceed immediately to step 5.

5. Turn the ignition from LOCK to ON 10 times within 15 seconds. The vehicle will respond with the lights flashing and an audible tone emitted, confirming it’s in programming mode. If you don’t see the lights or hear the noise, exit the vehicle and start the process over.

6. Open, then close the driver’s side door. The noise will continue to confirm the vehicle is still in programming mode.

7. Refer to the 8-digit code. While you still hear the noise, on the driver’s side door panel, press the LOCK button the number of times corresponding to the first digit. Once you’ve pressed it the correct number of times, press UNLOCK to move to the next digit. Repeat this for all 8 digits. Once you finish all 8 digits, press the UNLOCK button once. For example, if the code was 12345678 (use your code; this is just an example), you would:
– Press LOCK once, then UNLOCK.
– Press LOCK twice, then UNLOCK.
– Press LOCK three times, then UNLOCK, and so on.

8. You must now repeat step 7. Enter the 8-digit code on the driver’s side door. Once you enter the 8th digit, you’ll hear a tone for 30 seconds.

9. If you have additional remotes to program, repeat steps 5-8 for each additional remote. If you have no additional remotes, proceed to step 10.

10. Remove the key. Programming is now complete.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2005 Subaru Legacy