404 Not Found


nginx
404 Not Found

404 Not Found


nginx
How to Program a 2000 Toyota 4Runner Keyless Entry Remote Key Fob - KeyLessCanada : Instructions

Powered By
KeylessCanada.com

PROGRAMMING INSTRUCTIONS:

How to Program a 2000 Toyota 4Runner Keyless Entry Remote Key Fob

0
25

Compare
SKU: Remote Toyota 4Runner 2000 Categories: , , , Tags: , , ,

Description

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2000 Toyota 4Runner

Step-by-Step Programming Instructions:

1. Begin with the key out of the ignition, the driver’s door open, all other doors closed, and the driver’s door unlocked.
2. Insert the key into the ignition (do not turn) and then pull it out.
3. Complete the following steps within 40 seconds:
A. Use the power lock switch on the driver’s door to perform 5 lock/unlock cycles, starting with lock. Maintain an even pace, aiming for about one cycle per second (1 cycle = 1 lock and 1 unlock).
B. Close and then open the driver’s door.
4. Complete the following steps within 40 seconds:
A. Use the power lock switch on the driver’s door to perform 5 lock/unlock cycles, starting with lock. Maintain an even pace, aiming for about one cycle per second (1 cycle = 1 lock and 1 unlock).
B. Insert the key into the ignition cylinder.
C. Turn the ignition to ON (do not start) and then back to OFF once to program the remote while retaining the original remote codes. Twice to erase all original codes and add a new remote. Three times to check how many remotes are programmed or five times to erase all original codes.
D. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle automatically, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Complete the following steps within 40 seconds:
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after releasing the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once, indicating successful programming. If the door locks do not cycle, or cycle twice, repeat steps A and B in step 6 as your remote has not been accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Close the driver’s door.

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2000 Toyota 4Runner

Leave a reply

X
X