404 Not Found


nginx
404 Not Found

404 Not Found


nginx
How to Program a 1998 Chevrolet Prizm Keyless Entry Remote Key Fob - KeyLessCanada : Instructions

Powered By
KeylessCanada.com

PROGRAMMING INSTRUCTIONS:

How to Program a 1998 Chevrolet Prizm Keyless Entry Remote Key Fob

0
21

Compare
SKU: Remote Chevrolet Prizm 1998 Categories: , , , Tags: , , ,

Description

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1998 Chevrolet Prizm

Step-by-Step Programming Instructions:

The vehicle comes with two transmitters installed. The receiver has the capability to be programmed to recognize up to four transmitters. If more than four transmitters are programmed, the previously programmed ones will be erased in sequential order, starting from the first transmitter.

To program a transmitter, there are three modes within the remote control door lock receiver:

1. Add mode: This mode is utilized to add new or additional transmitters.
2. Rewrite mode: This mode is employed to erase all previously programmed transmitters and should be utilized when installing a new receiver.
3. Confirmation mode: This mode confirms the number of existing transmitters registered before adding any new transmitters.

Follow these steps:

1. Ensure the key is out of the ignition.
2. Open the driver’s door while keeping all other doors closed and unlocked.
3. Insert the key into the ignition (without turning it) and then remove it.
4. Complete the following steps within 40 seconds:
A. Use the power door lock switch on the driver’s door to perform 5 lock/unlock cycles, beginning with lock. Maintain an even pace, aiming for one cycle per second.
B. Close and then reopen the driver’s door.

Repeat the above steps, and then:
C. Insert the key into the ignition cylinder.
D. Turn the ignition to ON (without starting), and then back to OFF:
– Once to add a remote
– Twice to rewrite
– Three times for Confirmation Mode

Remove the key from the ignition. Depending on the mode selected:
– For Add or Rewrite mode: The doors will lock-unlock once or twice at 1-second intervals (once for Add mode, twice for Rewrite mode).
– For Confirmation mode: The doors will lock-unlock 0-4 times at 2-second intervals to indicate the number of transmitters programmed.

Press any button on the remote for 2 seconds. The doors will lock and unlock once to verify that the remote has been accepted.

For additional remotes:
6. Close the driver’s door, then reopen it.
7. Press any button on the remote for 2 seconds. The doors will lock and unlock once to verify that the remote has been accepted.
8. Repeat step 7 for up to 4 remotes.

9. Exit the car, close the driver’s door, wait 30 seconds, and then test the remote(s).

Click Hereto purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1998 Chevrolet Prizm

Leave a reply

X
X