Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1997 Cadillac Seville

Step-by-Step Programming Instructions:

For Seville Models with Analog Instrument Cluster:

1. Simultaneously press the OFF and WARM buttons on the Climate Control Panel (CCP). The Instrument Panel Cluster (IPC) will illuminate all tell-tales, then go blank, indicating the system is now in diagnostic mode. Press the PASSENGER COOLER button until “RFA” is displayed, then press FAN UP. If “RFADATA” appears, press FAN DOWN. If “RFAOVERRIDE” is displayed, press FAN UP.

2. If “RFA500NOOVERRIDE” is shown, press FAN DOWN. If “RFA501PROGRAMFOB#1” is displayed, press FAN UP.

3. The IPC will display “0” on the right side of the Driver Information Center (DIC) display. Press the warmer button on the climate control unit until “99” is displayed.

4. Press and hold the TRUNK button on the transmitter. While holding the TRUNK button, press the LOCK button and hold for one second. Hold both buttons for a total of 3 seconds. Locks will cycle when programming is complete. If the remote is not programmed within 30 seconds after entering “99” override display, the system will default, and you must begin again at step 2.

5. To program a second remote, press FAN DOWN button until “RFA502PROGRAMFOB#2” is displayed, then press FAN UP. Repeat step 4. To exit the system, press AUTO, MODE UP, MODE DOWN, or RESET.

For Seville Models with Digital Instrument Cluster:

1. Simultaneously press the OFF and WARM buttons on the Climate Control Center (CCC). The Instrument Panel Cluster (IPC) will light all tell-tales, go blank, then enter DIAGNOSTIC MODE. Press FAN DOWN button to scroll through the system until “RFA” is displayed, then press FAN UP button. Press FAN DOWN button until “RFAOVERRIDE” is displayed, then press FAN UP button. When “NOOVRDRF500” is displayed, press FAN UP button.

2. When “PGMFOBL501” is displayed, press WARM button and “99” will be displayed in the left upper corner of IPC just below odometer. The system is now ready to program the remote.

3. Press and hold the TRUNK button on the transmitter. While holding the TRUNK button, press LOCK button and hold for one second. Hold both buttons for a total of 3 seconds. Locks will cycle when programming is complete. If the remote is not programmed within 30 seconds after entering “99” override display, the system will default, and you must begin again at step 2.

4. To program a second remote, press FAN UP button until “PGMFOB2502” is displayed, then follow steps 2 and 3 to program the second remote. To exit the system, press RECIRC or RESET buttons.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1997 Cadillac Seville