How to Program a 1995 Jaguar XJ Keyless Entry Remote Key Fob

Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1995 Jaguar XJ

Step-by-Step Programming Instructions:

1. Open the boot lid and leave it open.
2. Open the driver’s door and leave it open.
3. Turn the ignition switch to the “ON” position but do not start the engine.
4. Rock the valet switch located in the center console five times. A single chirp and flash of the headlamps indicate that the Security Locking Control Module has entered the “learning” mode.
5. Press the alarm/lock (larger) button of the first transmitter. This transmitter will be linked to position 1 of the seat/steering/mirror memory. A tone will confirm that the transmitter code was accepted. Note that the button must be pushed within 15 seconds or the module will exit the “learning” mode.
6. Rock the valet switch once. Two short chirps will indicate the system is ready to accept a second transmitter. Press the arm/lock (larger) button of the second transmitter. Two tones will confirm the transmitter code was accepted.
7. Repeat steps 5 and 6 for up to a total of 5 transmitters. The second transmitter programmed will be linked to position 2; the third to position 3, and so forth. The number of confirmation chirps mentioned in step 6 will indicate the transmitter count (i.e., 3 chirps for the third transmitter). Note that you must cycle through steps 5 and 6 five times regardless of the number of transmitters; if you have fewer than 5 transmitters, just repeat using the last transmitter until 5 cycles have been finished.
8. Turn the ignition off, close the door and boot lid. Test for proper operation of the seat/steering/mirror memories.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 1995 Jaguar XJ