Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2011 Mitsubishi Eclipse

Step-by-Step Programming Instructions:

Programming Remote Instructions:

1. Locate the Data Port.
2. Insert keys into the ignition and leave them in the OFF position.
3. Ensure there are metal contact pins in terminals 1 and 4, and connect the Data Port with a suitable jumper wire. Keep the jumper wire connected throughout the programming procedure. Identify terminals 1 and 4 beforehand.
4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once, indicating that the system is in programming mode.
5. Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
6. Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
7. Disconnect the programming wire and remove the keys from the ignition.

Programming Key Instructions:

Note: You are provided with 2 keys, but you may add up to 6 more keys.

Customer key programming (Except for vehicles sold in Canada):

You can program new keys to the system if you have two valid (already registered) keys and blank (not registered) immobilizer keys (specially cut for your vehicle) by following these steps:

1. Insert the first programmed key into the ignition and turn the ignition to the “ON” position for 5 seconds.
2. Turn the ignition to the “LOCK” position and remove the first key.
3. Within 30 seconds of turning the first key to the “LOCK” position, insert the second programmed key into the ignition and turn it to the “ON” position. About 10 seconds later, the immobilizer indicator (on the dashboard) will start blinking.
4. When the immobilizer indicator starts blinking, turn the second valid key to the “LOCK” position and remove it. Within 30 seconds after doing so, insert a blank cut key into the ignition and turn it to the “ON” position. Perform this operation no more than 30 seconds after the immobilizer indicator starts blinking. When registration of the ID code is complete, the immobilizer indicator will come on for 3 seconds then go off. If an error occurs, the immobilizer indicator will go off during the procedure.
5. If you wish to program another key, perform the process again from step 1.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2011 Mitsubishi Eclipse