Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2013 Ford Fusion

Step-by-Step Programming Instructions:

For vehicles equipped with the remote/flip key system for the Ford Fusion, follow these instructions. You’ll need two previously programmed keys and the new unprogrammed key accessible. If you lack two previously programmed keys, you’ll require a locksmith to cut and program a second key. Alternatively, if you have one working key, you can rent a programmer.

1. Insert the first previously programmed key into the ignition.
2. Turn the ignition from off to on. Keep it on for at least three seconds but no more than ten seconds.
3. Turn the ignition off and remove the first programmed key.
4. After three seconds but within ten seconds of turning the ignition off, insert the second previously programmed key into the ignition.
5. Turn the ignition from off to on. Keep it on for at least three seconds but no more than ten seconds.
6. Turn the ignition off and remove the second previously programmed key.
7. After three seconds but within ten seconds of turning the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Turn the ignition from off to on. Keep it on for at least six seconds.
9. Remove the newly programmed key from the ignition. If the key has been successfully programmed, it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait ten seconds and repeat Steps 1 through 8.

For vehicles equipped with the smart key system:

Note: You can program a maximum of four smart keys to your vehicle. Follow the same instructions as above. Make sure the vehicle is off before starting the procedure. Ensure all doors are closed before starting and throughout the procedure. Perform all steps within 30 seconds of starting the sequence. If any steps are performed out of sequence, stop and wait for at least one minute before starting again.

1. Place a programmed smart key in the backup slot in the center console. The key ring must be at the top with the buttons facing toward the rear.
2. Wait 5 seconds, then press the START/STOP button.
3. Remove the smart key.
4. Within 10 seconds, place a second programmed smart key in the backup slot and press the START/STOP button.
5. Wait 5 seconds, then press the START/STOP button again.
6. Remove the smart key.
7. Wait 5 seconds, then place the unprogrammed smart key in the backup slot and press the START/STOP button. Programming is now complete. Verify the remote control functions operate and the vehicle starts with the new intelligent smart key. If programming was not successful, wait 10 seconds and repeat Steps 1 through 7.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2013 Ford Fusion