Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2022 Chevrolet Traverse

Step-by-Step Programming Instructions:

Each vehicle can be matched with up to eight transmitters. Here’s how to program them:

Programming with Recognized Transmitters:

A new transmitter can be programmed when there are two recognized transmitters. To start programming, ensure the vehicle is off and have all transmitters, both recognized and new, with you.

1. Remove the key lock cylinder cap on the driver door handle. Place the two recognized transmitters in the cup holder.
2. Insert the vehicle key into the key lock cylinder on the driver door handle and turn it counterclockwise to the unlock position five times within 10 seconds. The DIC (Driver Information Center) will display “READY FOR REMOTE #3, 4, 5, ETC.”
3. Place the new transmitter into the transmitter pocket located inside the center console storage area between the driver and front passenger seats, underneath the liner.
4. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will indicate readiness to program the next transmitter.
5. Remove the transmitter from the transmitter pocket and press Unlock or Lock on the transmitter. To program additional transmitters, repeat steps 3–5. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
6. Put the key back into the transmitter.
7. Replace the key lock cylinder cap.

Programming without Recognized Transmitters:

If two currently recognized transmitters are not available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. The procedure takes approximately 30 minutes to complete. Ensure the vehicle is off and have all transmitters you wish to program with you.

1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key into the key lock cylinder on the driver door handle and turn it counterclockwise to the unlock position five times within 10 seconds. The DIC displays “REMOTE LEARN PENDING, PLEASE WAIT.”
2. Wait for 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN” and then press ENGINE START/STOP. The DIC display will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
3. Repeat step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show “READY FOR REMOTE #1.”
4. Place the new transmitter into the transmitter pocket located inside the center console storage area between the driver and front passenger seats, underneath the liner.
5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will indicate readiness to program the next transmitter.
6. Remove the transmitter from the transmitter pocket and press Unlock or Lock on the transmitter. To program additional transmitters, repeat steps 4–6. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
7. Put the key back into the transmitter.
8. Replace the key lock cylinder cap.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2022 Chevrolet Traverse