Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2020 Chevrolet Suburban

Step-by-Step Programming Instructions:

**Programming with Recognized Transmitters (Keyless Access Vehicles Only):**
1. Take out the key from a recognized transmitter.
2. Place both recognized transmitters in the cup holder or on the passenger seat.
3. Insert the vehicle key into the key lock cylinder on the driver door handle and turn it counterclockwise to the unlock position five times within 10 seconds. The DIC will display “READY FOR REMOTE #3, 4, 5, etc.”
4. Put the new transmitter in the transmitter pocket/insert located in the center console storage area. Open the center console storage area and storage tray to access it.
5. Press ENGINE START/STOP. When the transmitter is learned, the DIC will indicate readiness to program the next transmitter.
6. Remove the transmitter from the transmitter pocket and press Unlock or Lock on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold ENGINE START/STOP for approximately 12 seconds to exit programming mode.
7. Return the key to the transmitter.

**Programming without Recognized Transmitters:**
1. Remove the vehicle key from the transmitter.
2. Insert the vehicle key into the key lock cylinder on the driver door handle and turn it counterclockwise to the unlock position five times within 10 seconds. The DIC will display “REMOTE LEARN PENDING, PLEASE WAIT.”
3. Wait for 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN,” then press ENGINE START/STOP. The DIC will again display “REMOTE LEARN PENDING, PLEASE WAIT.”
4. Repeat Step 3 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC should now display “READY FOR REMOTE #1.”
5. Place the new transmitter in the transmitter pocket/insert located in the center console storage area. Open the center console storage area and storage tray to access it.
6. Press ENGINE START/STOP. When the transmitter is learned, the DIC will indicate readiness to program the next transmitter.
7. Remove the transmitter from the transmitter pocket/insert and press Unlock or Lock on the transmitter. To program additional transmitters, repeat Steps 5–7. When all additional transmitters are programmed, press and hold ENGINE START/STOP for approximately 12 seconds to exit programming mode.
8. Return the key to the transmitter.

Note: This Smart Key is available here.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2020 Chevrolet Suburban