Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Chevrolet Corvette

Step-by-Step Programming Instructions:

Programming with a Recognized Transmitter:
IMPORTANT: This process is unavailable when the maximum number of four key fobs have been programmed. If four key fobs are already programmed to this RCDLR and this method is attempted, the driver information center (DIC) will display “MAX FOBS LEARNED” and exit the programming procedure. This process adds key fobs, numbering them in sequence based on when they are programmed. For instance, if two fobs are already programmed, a fob programmed using this method will be numbered as Fob 3. You’ll need a known good key fob, a replacement key fob, and the vehicle’s mechanical key.

1. Ensure the vehicle is off.
2. Open the rear compartment.
3. Place a known key fob inside the vehicle.
4. Insert the vehicle key into the rear compartment lock cylinder, located above the license plate, and cycle the key five times within five seconds.
5. The DIC will display: “READY FOR FOB X (X = fob 2, 3, or 4).”
6. Place the replacement key fob in the glove box fob pocket with the buttons facing right.
7. A beep will occur, and the DIC will display: “READY FOR FOB X (X = fob 3 or 4)” or “MAX FOBS LEARNED.”
8. If programming additional key fobs, repeat steps 5 and 6, or press the OFF/ACC portion of the ignition switch to exit programming mode.
9. Test each key fob to verify correct system operation.

Programming without a Recognized Transmitter:
This process erases all previously programmed key fobs. You’ll need a replacement key fob and a mechanical key. Ensure no known good key fobs are nearby during this process, or the programming mode will resort to the ADD procedure.

1. With the vehicle off, open the rear compartment.
2. Place the replacement key fob in the glove box pocket with the buttons facing right.
3. Insert the mechanical key into the lock cylinder located above the license plate and cycle the key five times within five seconds.
4. The DIC will display: “OFF/ACC TO LEARN.”
5. Press the OFF/ACC portion of the ignition button.
6. The DIC will display: “WAIT 10 MINUTES,” then it will count down from 10 to 0 one minute at a time.
7. When the counter reaches 0, the DIC will display “OFF/ACC TO LEARN” again.
8. Repeat steps 5-6 two more times for a total of 30 minutes.
9. A beep will sound, and the DIC will display: “READY FOR FOB 1.” At this point, all previously programmed key fobs have been erased. When fob 1 is programmed, a beep will sound, and the DIC will display: “READY FOR FOB 2.”
10. Additional key fobs can be programmed by taking out fob 1 from the pocket and inserting fob 2. You can program up to four fobs. If you program four key fobs, the DIC will display: “MAX FOBS LEARNED” and automatically exit the program mode. If you programmed fewer than four key fobs, press the OFF/ACC ignition button to exit the program mode.
11. Test all key fobs.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2008 Chevrolet Corvette