Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Buick Envision

Step-by-Step Programming Instructions:

Programming with Two Recognized Transmitters

When there are two recognized transmitters, a new transmitter can be programmed to the vehicle. To proceed:

1. Ensure the vehicle is turned off and have all transmitters, both recognized and new, with you.
2. Place the recognized transmitters in the front cupholder.
3. Insert the vehicle key of the new transmitter into the keylock cylinder on the outside of the driver door. Turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) will display READY FOR REMOTE #2, #3, #4, or #5.
4. Place the new transmitter in the front cupholder.
5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC will indicate readiness to program the next transmitter.
6. Remove the transmitter from the transmitter pocket and press unlock. To program additional transmitters, repeat steps 4–6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.

Programming without Two Recognized Transmitters

If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. Note: This feature is not available in Canada.

1. Ensure the vehicle is turned off and have all the transmitters to be programmed with you.
2. Insert the vehicle key of the transmitter into the keylock cylinder on the outside of the driver door. Turn the key to the unlock position five times within 10 seconds. The DIC will display REMOTE LEARN PENDING, PLEASE WAIT.
3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN. Then, press the ENGINE START/STOP button. The DIC will again show REMOTE LEARN PENDING, PLEASE WAIT.
4. Repeat step 3 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned in the next steps. The DIC display should now show READY FOR REMOTE #1.
5. Place the new transmitter into the front cupholder.
6. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC will indicate readiness to program the next transmitter.
7. Remove the transmitter from the cupholder and press unlock. To program additional transmitters, repeat steps 5–7. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Buick Envision