Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Chevrolet Equinox

Step-by-Step Programming Instructions:

Programming with two recognized transmitters:

1. Remove the key lock cylinder cap on the driver door handle. Place the two recognized transmitters in the cup holder.
2. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays “READY FOR REMOTE #2, 3, 4, ETC.”
3. Place the new transmitter into the cup holder.
4. Press ENGINE START/STOP. When the transmitter is learned, the DIC display will indicate readiness to program the next transmitter.
5. Remove the transmitter from the cup holder and press UNLOCK or LOCK on the transmitter. To program additional transmitters, repeat Steps 3–5. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
6. Put the key back into the transmitter.

**Programming without two recognized transmitters:**

If two recognized transmitters are not available, follow this procedure to program up to eight transmitters. Note: This feature is not available in Canada and will take approximately 30 minutes to complete. Ensure the vehicle is off and all transmitters you wish to program are with you.

1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the transmitter into the key lock cylinder on the driver door handle and turn the key counterclockwise to the unlock position five times within 10 seconds. The DIC displays “REMOTE LEARN PENDING, PLEASE WAIT.”
2. Wait for 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN” and then press ENGINE START/STOP. The DIC display will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
3. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show “READY FOR REMOTE #1.”
4. Place the new transmitter into the cup holder.
5. Press ENGINE START/STOP. When the transmitter is learned, the DIC display will indicate readiness to program the next transmitter.
6. Remove the transmitter from the cup holder and press UNLOCK or LOCK on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
7. Put the key back into the transmitter.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2018 Chevrolet Equinox