How to Program a 2022 Cadillac XT5 Ignition Smart Chip Key Transponder

Step by Step How to Programming Instructions:

To program a new key:
1. Insert the original, already programmed key into the ignition and turn it to the ON/RUN position.
2. Turn the key to LOCK/OFF and remove it.
3. Insert the new key to be programmed and turn it to the ON/RUN position within five seconds. The security light will turn off once the key has been programmed.
4. Repeat Steps 1–3 if additional keys are to be programmed.

Programming without a Recognized Chip Key Vehicles Only:
If you don’t have a recognized chip key, you’ll need to contact a locksmith in your area. Use the following procedure if you have a programmed remote and want to add another (Smart Key System Only):
1. Ensure the vehicle is off.
2. Have the recognized transmitter and the new, unrecognized transmitter(s) with you.
3. Insert the key into the key lock cylinder located on the outside of the driver’s door.
4. Turn the key to the unlock position five times within five seconds.
5. The Driver Information Center (DIC) displays “Ready to Learn Electronic Key #2, 3, or 4”.
6. Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle (located inside the center console between the driver and front passenger seats).
7. A beep sounds once the remote is programmed. The DIC displays “Ready to Learn Electronic Key #3 or 4, or Maximum # Electronic Keys Learned”.
8. Press the ignition control knob to exit programming mode.
9. Remove the remote from the transmitter pocket and press unlock to the remote two times.
10. To program additional remotes, repeat Steps 6 through 9.

Use the following procedure if you have no working remotes (Smart Key System Only):
1. Ensure the vehicle is off.
2. Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle (located inside the center console between the driver and front passenger seats).
3. Insert the key into the key lock cylinder located on the outside of the driver’s door.
4. Turn the key to the unlock position five times within five seconds.
5. The DIC displays “Ready to Learn Keys”.
6. Press the ignition switch in.
7. The DIC reads “Learn Delay Active Wait XX Min” and counts down to zero.
8. The DIC displays “Press Start Control To Learn Keys again”.
9. Press the ignition switch in again.
10. Repeat Steps 7, 8, and 9.
11. The DIC reads “Learn Delay Active Wait XX Min” and counts down to zero.
12. A beep sounds and the DIC reads “Ready To Learn Electronic Key #X”. All previously known remote programming has been erased.
13. A beep sounds once programming is complete. The DIC displays “Ready To Learn Electronic Key #2”.
14. To program additional remotes, insert each transmitter into the pocket until a beep is heard and the DIC advances to the next electronic key number. Up to four remotes can be programmed. The DIC displays “Maximum # Electronic Keys Learned” and exits the programming mode.
15. Press the ignition control knob if programming is complete.
16. Press unlock on each newly programmed remote to complete the process.