How to Program a 2016 Ford Explorer Ignition Smart Chip Key Transponder

Step by Step How to Programming Instructions:

For Ford Escape with the remote/key combo, follow these steps if you have two previously programmed keys and the new unprogrammed key ready. If you lack two previously programmed keys, consult a locksmith for a second key.

1. Insert the first programmed key into the ignition.
2. Turn the ignition from off to on, keeping it on for at least three seconds but no more than ten seconds.
3. Turn the ignition off and remove the first programmed key.
4. After three seconds but within ten seconds of turning the ignition off, insert the second programmed key into the ignition.
5. Turn the ignition from off to on, keeping it on for at least three seconds but no more than ten seconds.
6. Turn the ignition off and remove the second programmed key.
7. After three seconds but within ten seconds of turning the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
8. Turn the ignition from off to on, keeping it on for at least six seconds.
9. Remove the newly programmed key. If successfully programmed, it will start the engine and operate the remote entry system (if integrated).
10. If unsuccessful, wait 10 seconds and repeat steps 1 through 8.

For Ford Escape with the smart key system:
Note: You can program a maximum of eight programmed keys, all being intelligent access keys. Follow these steps to program your own keys. Ensure the ignition is switched off before starting and that all doors are closed throughout the procedure. Complete all steps within 30 seconds of starting the sequence. If steps are carried out out of sequence, stop and wait at least one minute before starting again.

1. Place the first programmed intelligent access key in the middle of the tray.
2. Press the push-button ignition switch.
3. Wait five seconds, then press the push-button ignition switch again.
4. Remove the intelligent access key.
5. Within 10 seconds, place a second programmed intelligent access key in the middle of the tray.
6. Press the push-button ignition switch.
7. Wait five seconds, then press the push-button ignition switch again.
8. Remove the intelligent access key.
9. Within 10 seconds, place the unprogrammed intelligent access key in the middle of the tray.
10. Press the push-button ignition switch, keeping it on for at least six seconds.
11. Remove the newly programmed intelligent access key. Programming is complete. Check remote control functions and engine start. If unsuccessful, wait 10 seconds and repeat steps 1 through 11.