How to Program a 2014 Mazda 2 Ignition Smart Chip Key Transponder
Step by Step How to Programming Instructions:
1. Ensure you have two previously programmed remote controls inside your vehicle and the new, unprogrammed remote control readily accessible.
2. Turn off your vehicle before starting the procedure.
3. Close all doors and ensure they remain closed throughout the procedure.
4. Complete all steps within 30 seconds of starting the sequence.
5. If any steps are performed out of sequence, stop and wait for at least one minute before starting again.
6. Note: You can program a maximum of four remote controls to your vehicle.
7. Place the first programmed remote in the backup slot inside the center console.
8. With your foot off the brake pedal, press and release the push-button ignition switch.
9. Wait five seconds, then press and release the push-button ignition switch again.
10. Remove the remote control.
11. Within 10 seconds, place a second programmed remote control in the backup slot.
12. Press and release the push-button ignition switch.
13. Wait five seconds, then press and release the push-button ignition switch again.
14. Keep the ignition on for at least 3 seconds, but no more than 10 seconds.
15. Remove the remote control.
16. Place the unprogrammed remote control in the backup slot and press and release the push-button ignition switch.
17. Programming is now complete.
18. With your foot on the brake pedal, press the push-button ignition switch to verify the remote control functions operate and your vehicle starts with the new remote control.
19. If programming was not successful, wait 10 seconds and repeat Steps 1 through 7.
20. If all keys are lost for this vehicle, follow these steps:
a. Locate an automotive locksmith in your area by visiting LocateALocksmith.com.
b. If your vehicle is still mobile, consider driving to the locksmith to potentially save money.
c. The locksmith will hook up specialized computer equipment to your vehicle to program the smart key remote fob.
