How to Program a 2012 Buick Regal Ignition Smart Chip Key Transponder
Step by Step How to Programming Instructions:
These programming steps are applicable only for vehicles built in the USA. The first digit of your 17-digit VIN number must begin with the number 1 or 4. If your VIN starts with 2, 3, or a letter, these instructions will not apply.
Can I program a new key myself if I have no working keys?
Yes, once you have had the new key cut by a locksmith, follow the instructions below:
1. Insert the new cut key into the ignition and turn it to the ON position for 10 minutes and 30 seconds.
2. Within 45 seconds, turn the key to OFF and then back to the ON position for 10 minutes and 30 seconds.
3. Within 45 seconds, turn the key to OFF and then back to the ON position for 10 minutes and 30 seconds.
4. Turn the key OFF, then back ON. The key is now programmed. Start the vehicle to test the key.
Can I program a duplicate key for this vehicle?
Yes, once you have had the new key cut by a locksmith, follow the instructions below:
1. Insert an existing programmed working key into the ignition cylinder.
2. Turn the ignition to the ON position for 5 seconds, then back to the OFF position.
3. Remove the existing key and within 5 seconds, insert the new key and turn it to the ON position for 5 seconds.
4. Turn the key OFF, then back to ON. The key is now programmed. Start the vehicle to test the key. Visit keylesscanada.com for keyless entry remote fob programming.
