How to Program a 2010 Lincoln MKZ Ignition Chip Key Transponder
Step by Step How to Programming Instructions:
**Step-by-Step Programming Instructions: Programming a Spare Intelligent Access Key**
To program a spare intelligent access key for your vehicle, you can program up to four keys in total. You’ll need two previously programmed intelligent access keys inside your vehicle, along with the new unprogrammed intelligent access key. If you don’t have two previously programmed keys available, you’ll need to contact a locksmith to have the spare key programmed.
Before starting the programming procedure, ensure that your vehicle is turned off and that all doors are closed.
Follow these steps within 30 seconds of starting the sequence, and if you perform any steps out of sequence, stop and wait for at least one minute before starting again.
It’s essential to read and understand the entire procedure before beginning.
1. Insert the first programmed key into the backup slot inside the glove compartment, then press the push-button ignition switch.
2. Wait five seconds, then press the push-button ignition switch again.
3. Remove the intelligent access key.
4. Within 10 seconds, insert a second programmed intelligent access key into the backup slot. Press the push-button ignition switch.
5. Wait five seconds, then press the push-button ignition switch again.
6. Remove the intelligent access key.
7. Place the unprogrammed intelligent access key into the backup slot and press the push-button ignition switch. Programming is now complete.
Verify that the remote control functions operate and your vehicle starts with the new intelligent access key. If programming was not successful, wait 10 seconds and repeat Steps 1 through 7.
