How to Program a 2010 Ford Edge Ignition Smart Chip Key Transponder
Step by Step How to Programming Instructions:
1. Begin with two previously programmed keys and the new unprogrammed key readily accessible. If you don’t have two previously programmed keys, you’ll need a locksmith to cut and program a second key.
2. Insert the first previously programmed key into the ignition.
3. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
4. Switch the ignition off and remove the first programmed key from the ignition.
5. After three seconds but within ten seconds of switching the ignition off, insert the second previously programmed key into the ignition.
6. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than ten seconds.
7. Switch the ignition off and remove the second previously programmed key from the ignition.
8. After three seconds but within ten seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.
9. Switch the ignition from off to on. Keep the ignition on for at least six seconds.
10. Remove the newly programmed key from the ignition. If the key has been successfully programmed, it will start the engine and operate the remote entry system (if the new key is an integrated key head transmitter). If it was not programmed successfully, wait ten seconds and repeat Steps 1 through 8.
