How to Program a 2008 Dodge Nitro Ignition Chip Key Transponder

Step by Step How to Programming Instructions:

Note: You can program a maximum of four remote controls to your vehicle. You must have two previously programmed remote controls inside your vehicle and then the new unprogrammed remote controls readily accessible. Make sure that your vehicle is off before beginning this procedure. Ensure that you close all the doors before beginning and that they remain closed throughout the procedure. Perform all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you perform any steps out of sequence. Read and understand the entire procedure before you begin.

1. Open the center console lid.
2. Place the first programmed remote in the backup slot inside the center console. With your foot off the brake pedal, press and release the push-button ignition switch. Wait a few seconds and then press and release the push-button ignition switch again. Remove the remote control.
3. Within 10 seconds, place a second programmed remote control in the backup slot. Press and release the push-button ignition switch. Wait a few seconds and then press and release the push-button ignition switch again. Keep the ignition on for a few seconds, but no more than 10 seconds. Remove the remote control.
4. Place the unprogrammed remote control in the backup slot and press and release the push-button ignition switch. Programming is now complete.
5. With your foot on the brake pedal, press the push-button ignition switch to verify the remote control functions operate and your vehicle starts with the new remote control.