How to Program a 2002 Dodge Intrepid Ignition Chip Key Transponder

Step by Step How to Programming Instructions:

Note: You must possess two valid keys to add a new key to the system. If you lack two working keys, you will need to consult a locksmith to program a key for you.

1. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key.

2. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound, and the Vehicle Security Light will start flashing. Turn the ignition switch to the LOCK position and remove the second key.

3. Insert the new key into the ignition switch. Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime will sound, and the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle Security Light will turn on again for a few seconds and then turn off. The new key is now programmed. The Remote Keyless Entry transmitter will also be programmed during this procedure. Repeat this procedure to program up to eight keys.