How to Program a 2009 Lincoln MKS Ignition Smart Chip Key Transponder

Step by Step How to Programming Instructions:

Note: You can program a maximum of four keys to your vehicle. You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access keys readily accessible. If two previously programmed keys are not available, contact a locksmith to have the spare key programmed. Ensure that the ignition is switched off before beginning this procedure. Also, make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence. Read and understand the entire procedure before you begin.

1. Open the floor console storage compartment lid.
2. Insert the passive key into the backup slot.
3. Press the push-button ignition switch.
4. Wait five seconds and then press the push-button ignition switch again.
5. Remove the intelligent access key.
6. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push-button ignition switch.
7. Wait five seconds and then press the push-button ignition switch again.
8. Remove the intelligent access key.
9. Wait five seconds, then place the unprogrammed intelligent access key in the backup slot and press the push-button ignition switch.

Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key.