Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2016 Cadillac XTS

Step-by-Step Programming Instructions:

Programming a new transmitter to the vehicle can be done when there is one recognized transmitter. To start programming, ensure the vehicle is turned off, and all transmitters, both recognized and new, are with you.

1. Open the center console storage area and the storage tray.
2. Place the recognized transmitter(s) in the pocket located inside the center console storage area between the driver and front passenger seats.
3. Remove the key lock cylinder cap. Insert the vehicle key into the key lock cylinder on the driver door handle. Turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) will display “READY FOR REMOTE #2, 3, 4, ETC.”
4. Replace the recognized transmitter with a new one. Place the new transmitter in the transmitter pocket.
5. Press the ENGINE START/STOP button.
6. Remove the transmitter from the pocket and press unlock or lock on the transmitter. To program additional transmitters, repeat steps 4–6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

Programming Instructions without a Recognized Transmitter:

If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. Ensure the vehicle is turned off, and all transmitters to be programmed are with you.

1. Remove the key lock cylinder cap. Insert the vehicle key into the key lock cylinder on the driver door handle. Turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) will display “REMOTE LEARN PENDING, PLEASE WAIT.”
2. Wait for 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN,” then press the ENGINE START/STOP button. You may have to open and close the driver’s door to see the DIC display. The DIC will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
3. Repeat step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. The DIC displays “PRESS ENGINE START BUTTON TO LEARN,” then press the ENGINE START/STOP button. Remaining transmitters can be relearned during the next steps. The DIC display should now show “READY FOR REMOTE #1.”
4. Place the new transmitter in the transmitter pocket with buttons facing the rear of the vehicle. The transmitter pocket is inside the center console storage area between the driver and front passenger seats. The storage area will need to be opened to access the transmitter pocket.
5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
6. Remove the transmitter from the pocket and press unlock or lock on the transmitter. To program additional transmitters, repeat steps 4–6. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2016 Cadillac XTS