Description

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2019 Chevrolet Volt

Step-by-Step Programming Instructions:

When programming a new transmitter to the vehicle with two recognized transmitters already in place, follow these steps:

1. Place the two recognized transmitters in the cupholder.
2. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door. Turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) will display “READY FOR REMOTE #2, 3, 4, OR 5,” etc.
3. Remove the rubber mat in the center console storage area.
4. Place the new transmitter in the transmitter pocket.
5. Press and hold the engine start/stop button on the center stack for two seconds. When the transmitter is programmed, the DIC will indicate that it is ready to program the next transmitter.
6. Remove the transmitter from the transmitter pocket and press the unlock or lock button on the transmitter. To program additional transmitters, repeat steps 4–6. Once all additional transmitters are programmed, press and hold the POWER button for 12 seconds to exit programming mode.
7. Return the key back into the transmitter.

Programming without a Recognized Transmitter:

To program a new key to the vehicle when a recognized key is not available, follow this procedure, which can accommodate up to eight transmitters. Note: Canadian regulations may require owners to visit their dealer. This process will take approximately 30 minutes to complete. The vehicle must be off, and all transmitters to be programmed must be with you.

1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The DIC will display “REMOTE LEARN PENDING, PLEASE WAIT.”
2. Wait for 10 minutes until the DIC displays “PRESS START BUTTON TO LEARN,” then press the POWER button on the center stack. The DIC will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
3. Repeat step 2 two more times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be programmed during the next steps. The DIC display should now show “READY FOR REMOTE #1.”
4. Remove the rubber mat in the center console storage area.
5. Place the new transmitter into the transmitter pocket.
6. Press and hold the POWER button for two seconds. When the transmitter is programmed, the DIC will indicate that it is ready to program the next transmitter.
7. Remove the transmitter from the transmitter pocket and press unlock on the transmitter. To program additional transmitters, repeat steps 5–7. Once all additional transmitters are programmed, press and hold the POWER button for 12 seconds to exit programming mode.
8. Return the key back into the transmitter.

to purchase Auto Keys, Fobs, Remotes, Shell/Cases & Related products for 2019 Chevrolet Volt